How To Finish Butcher Block For Desk. Avoid using wax or oil products because they will damage the wood over time. So the butcher block is resting on that “lip” and the two drawer units on each side.
How to Build a Modern DIY Desk with Butcher Block Hardwood Reflections from hardwoodreflections.com
Refer to manufacturer for dry times and number of coats. Cut out for any structures in the way if wall mounting. Then apply a second coat again on all surfaces.
Table of Contents
Just Did This For My Setup.
To finish a custom kitchen desk made from kitchen cabinets that were cut down i needed to stain and finish the butcher block top. Clean the surface every week or so with a mild soap and water. Also with water based finishes the water tends to raise the grain making for a lot more coats and sanding between coats to achieve the same finish as you could get with the oil based finish.
You Need To Put On The First Coat Of Water Polyurethane On All Surfaces With A Foam Brush Not Just The Top And Sides.when It Has Completely Dried Lightly Sand It With Higher Grit Sand Paper.
How to finish butcher block for desk. He also used a few screws and attached the butcher block to. Cut materials to butcher block style.
Use A Track Saw, Or Similar To Break Down Your Standard Butcher Block Counter Top Into Main Desk Top, And Any Legs (As Required).
Oil based stain with a thick gel like consistency helps enhance the beauty of the wood. How to finish butcher block for desk cut out for any structures in the way if wall mounting. Refer to manufacturer for dry times and number.
Apply Mineral Spirits To The Top And Allow To Dry.
@drzaius i already purchased and cut the wood so i must go down the birch path, but thanks for the suggestion.its going to be a pretty large corner desk with 3 pieces, the wings are 6'x2.5' and the middle is 3'x2.5'. When making cuts, be sure to protect the finish. Sometimes has vegetable oil mixed in.
Let It Dry Completely Before Using The Desk Again.
Thanks so much for the replies! I think by far the easiest finish is food grade mineral oil. It should hold up to anything, including the odd drip of tea or coffee.
